Sprinkler coverage checking against the real geometry.
Sprinkler coverage checking finds areas without heads, spacing problems and obstructions by beams and ducts in a BIM model, against the standard the project uses (NFPA 13, BS EN 12845 or local code).
What is sprinkler coverage checking?
Sprinkler coverage checking compares the sprinkler layout with the spaces it protects: is every area covered, is spacing within the limit for the hazard class, and do beams, ducts or ceilings obstruct the spray. Because it uses the 3D model, it can see obstructions that a 2D layout hides.
What the code asks for
- Sprinkler design follows the standard the project adopts, such as NFPA 13, BS EN 12845 or the national code, selected by hazard classification.
- Every protected area is covered, including voids and spaces below obstructions where the standard requires it.
- Head spacing and area per head stay within the limits for the hazard.
- Beams, ducts and other elements do not obstruct the spray pattern beyond what the standard allows.
The exact values (ratings, distances, widths, densities) come from the code edition your authority applies, so a check always reports which edition and clause it used.
How it shows up in an IFC model
| Item | IFC entity | What a check reads |
|---|---|---|
| Sprinkler head | IfcFireSuppressionTerminal with predefined type SPRINKLER | Position, spacing and count |
| Protected space | IfcSpace | Area and hazard classification |
| Pipework | IfcPipeSegment | Whether heads are connected |
| Obstructions | IfcBeam, IfcDuctSegment | Elements below or near heads that block spray |
| Ceilings and voids | IfcCovering, IfcSpace | Where protection may be needed above or below |
Why models fail this check
- Spaces with no heads because the sprinkler layout was only drawn for part of a floor.
- Heads obstructed by a deep beam or a large duct below them.
- Spacing exceeds the limit for the hazard class.
- Hazard class not recorded, so the wrong spacing is assumed.
- Heads not connected to pipework in the model.
What a Verify AI finding looks like
Example finding: head obstructed by duct
Severity: MEDIUM
Element: IfcFireSuppressionTerminal (SPRINKLER)
Location: Level 5, east wing
Detected: a duct below the head blocks the spray pattern
Action: relocate the head or the duct, or add heads below the obstruction as the standard allows
This is an illustrative example. Every finding is pinned to the plan, names the element, and cites the clause it was checked against. See a full sample report.
How to prepare your model
- Record the hazard class: set it on each space.
- Model every head: include all heads and the pipework that feeds them.
- Federate with HVAC and structure: so obstructions are visible.
- Check voids: review ceiling and floor voids.
- State the standard: name the sprinkler standard in the design basis.
Frequently asked questions
Which standards does the check use?
The one the project adopts, for example NFPA 13, BS EN 12845 or the local code. The report states which one it used.
Does it design the sprinkler system?
No. It reviews a design for coverage, spacing and obstructions. Hydraulic design and calculations remain with the sprinkler designer.
Why check obstructions in 3D?
A 2D layout shows heads but not the beams and ducts that sit below them. In a model those obstructions are visible.
Related
- BIM fire compliance checking: the complete guide
- Clearance zone checking
- Service penetrations and fire-stopping
- Stair pressurisation
- How to check an IFC model for building code compliance