Stair pressurisation checking between architecture and HVAC.
Stair pressurisation checking confirms enclosed stairs have fans, supply routes and relief paths modelled, so smoke is kept out of the escape route. See what is checked in a BIM model.
What is stair pressurisation checking?
Stair pressurisation keeps smoke out of an escape stair by supplying air so the stair stays at a higher pressure than the rest of the building. It only works if the architectural stair, the fan, the supply duct and the air relief path are all present and connected. Checking that across two disciplines is the kind of cross-model task an automated check handles well.
What the code asks for
- Stairs that need pressurisation under the applicable code have a fan, a supply route and a relief path.
- Doors, shafts and leakage paths around the stair are consistent with the design basis.
- Smoke control designs follow the standard the project adopts (for example NFPA 92 where it is referenced, or the national code).
- Fans have emergency power where required.
The exact values (ratings, distances, widths, densities) come from the code edition your authority applies, so a check always reports which edition and clause it used.
How it shows up in an IFC model
| Item | IFC entity | What a check reads |
|---|---|---|
| Enclosed stair | IfcStair, IfcSpace for the enclosure | Which stairs are protected enclosures |
| Pressurisation fan | IfcFan | Presence and location of the fan |
| Supply duct | IfcFlowSegment, IfcDuctSegment | Whether the fan is connected to the stair |
| Relief path | IfcDamper, IfcAirTerminal, openings | Where air can leave the building floors |
| Stair doors | IfcDoor | Door properties and rating at the enclosure |
Why models fail this check
- Stair shown in the architectural model but no pressurisation fan in the HVAC model.
- Fan modelled but not connected to the stair by duct.
- No relief path, so the stair cannot hold the design pressure range.
- Architectural and MEP models using different names or levels for the same stair.
- Fan not on the emergency power supply.
What a Verify AI finding looks like
Example finding: stair has no supply route
Severity: HIGH
Element: IfcStair "Stair 2"
Location: Levels B1 to 14
Detected: no pressurisation fan connected to the enclosure
Impact: stair may not be protected against smoke
Action: confirm the design basis and model the fan, duct and relief path
This is an illustrative example. Every finding is pinned to the plan, names the element, and cites the clause it was checked against. See a full sample report.
How to prepare your model
- Name stairs consistently: use the same identifiers in every model.
- Model the whole system: fan, duct, outlets and relief.
- Connect the system: check the duct reaches the stair.
- Check power: confirm the fan is on the emergency supply.
- Agree the standard: state which smoke control standard the design uses.
Frequently asked questions
What does a stair pressurisation system do?
It supplies air to an escape stair so that, if there is a fire elsewhere, smoke is pushed out of the stair and people can use it safely.
Do all stairs need it?
No. Whether a stair needs pressurisation depends on the building height, use and the code. The check applies the rule from the edition you select.
Why check it in the model?
Because it spans two disciplines. A stair on the architect's drawings and a fan on the engineer's are easy to leave unconnected until late in a project.
Related
- BIM fire compliance checking: the complete guide
- Clearance zone checking
- Service penetrations and fire-stopping
- Emergency lighting
- How to check an IFC model for building code compliance